If you own a S&W V-Comp Revolver in any caliber we have the replacement sight for you.
Our Dove Tail Front Sights are 0.100" wide and have a red fiber dot of 0.075" diameter. Green fiber may be exchanged
These sights are direct replacements for the S&W factory sights.
You need to drive the old sight out and press the new on in. Some fitting may be required but typically not.
Note: We recommend that you drive the old sight out from right to left as you are looking down the barrel with the gun pointed away.
And the drive the new sight in from left to right. This keeps from passing the sight completely through the dove tail and loosening it up..
These are available in the following heights: 0.219", 0.249", 0.280" 0.312" and 0.352" The height is measured from the bottom of the sight base to the top.
All sight bases are 0.3750 at the widest part of the base and the base angle is approximately 45 degrees.
14 Reviews Hide Reviews Show Reviews
Easy install. No fitting was required. Installed it in about 10 minutes using brass punch set. Faster target acquisition and much improved line of site. Aesthetically, my S&W 44 magnum V comp so sexy now! Highly recommend this product.
Fit perfectly. Made well. Very prompt!
perfect fit on my snubnose performance center 629 and 627....my old eyes can see the front sight much much better and the quality is excellent
LPA sight from S&W was too low from factory. Replacement fiber optic from Revolver Supply was great, perfect fit and brought the impact down to the aim point. Thank you
If you have concerns about fit or finish of the Revolver Supply Co. replacement fiber optic dovetail front sight for S&W revolvers, .... rest easy! Following the instructions for direction of remove/install, this was a perfect retrofit to my 686+ 2 1/2" PC revolver. I used an aluminum drift and a polymer bench block and the result is exactly as I desired.
Badass front sight. Can’t figure out how to post a picture. Smart phone, stupid human. Amazing fit and finish. You can’t go wrong with this company. No filing was necessary. The sight locked home immediately and it’s going nowhere. I have a few more accessories that I need to make my s&w project perfect and I will be buying the parts from Revolver Supply!
This company really has their game together. They are extremely knowledgeable, efficient, and courteous. They are willing to answer questions and elicit feedback. For the fans of the wheel gun this is your last stop. Brownells and Midway have nothing on them.
The sight fit my S&W Competitor perfect. This new sight is much easier for me to get on target then the factory sight. It was easy to install and fit perfectly,
The next day after installing it, I wiped it with a cloth and the ring that holds the fiberoptic farthest from the muzzle flaked off without any force. GM we are sending a replacement right now.